English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This study presents the Taguchi method and the Particle Swarm Optimization (PSO) technique which uses mutation (MPSO) and dynamic inertia weight to determine the best ranges of process parameters (extrusion velocity, eccentricity ratio, billet temperature and friction coefficient at the die interface) for a multi-hole extrusion process. A L 18(2 1 ×3 7 ) array, signal-to-noise (S/N) ratios and analysis of variance (ANOVA) at 99% confidence level were used to indicate the optimum levels and the effect of the process parameters with consideration of mandrel eccentricity angle and exit tube bending angle. As per the Taguchi-based MPSO algorithm using DEFORM TM 3D Finite Element Analysis (FEA) software, the minimum mandrel eccentricity and exit tube bending angles were respectively calculated to be 0.03°, which are significantly less than those based on Genetic Algorithm (GA) and the Taguchi method, respectively. This indicates that the Taguchi-based MPSO algorithm can effectively and remarkably reduce the warp angles of Ti-6Al-4V extruded products and the billet temperature is the most influencing parameter. The results of this study can be extended to multi-hole extrusion beyond four holes and employed as a predictive tool to forecast the optimal parameters of the multi-hole extrusion process.

Application of ANOVA and Taguchi-based Mutation Particle Swarm Algorithm for Parameters Design of Multi-hole Extrusion Process