English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The epoxy resin in the form of Etal Inject-T compound, Sigratex KDK carbon fabric, Taunit-M carbon nanotubes conditionally named as CNT-1, as well as functionalized (modified) variety of them by grafting to the surface of new chemical groups: carboxylated ‒ CNT-2, carboxyl-hydroxylated ‒ CNT-3, amidated ‒ CNT-4 were used in the work. The experiments were performed on the compression strength and bending strength of the samples. The injection of CNT-1 into epoxy resin or carbon fiber reinforced plastic did not produce the hardening. The injection of 0.05% of CNT-2 into the epoxy resin had the following effect: there is no influence in the area of quasielastic strains, the hardening was up to 25% in the areas of plastic and elastic-plastic strain. The injection of 0.15% of functionalized carbon nanotubes into the carbon fiber reinforced plastic produced the hardening for compression with CNT-2 ‒ 6%, CNT-3 ‒ 12%, CNT-4 – 17%, for bending – CNT-2 – 44%, CNT-3 – 59%, CNT-4 – 132%. It is established that with an increase in the strain rate of epoxy resin from 1 to 5 mm/min the areas of plastic and elastic-plastic strain gradually are reduced, there is only quasielastic strain with brittle fracture at 20 mm/min, this value can be accepted as its strength characteristic. With an increase in the strain rate of carbon fiber reinforced plastic from 1 to 20 mm/min the compression strength gradually increases from 398 MPa to 425 MPa, and then stabilizes.

Characterization of the Epoxy Resin and Carbon Fiber Reinforced Plastic Stress-Strain State by Modified Carbon Nanotubes