English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

. The efficiency of a hemodialyzer is largely dependent on its ability to facilitate diffusion between blood and dialysis solution. The diffusion process can be impaired if there is a mismatch between blood and dialysate flow distribution in the dialyzer. This article describes the distribution of the blood and dialysate flows in hollow-fiber hemodialyzers analyzed with a computerized scanning technique. Blood flow distribution was studied  in vitro  by dye injection in the blood compartment during experimental extracorporeal circulation using human blood with hematocrit (Hct) adjusted at 25 and 40%. Sequential images were obtained with a helical scanner in a 1-cm-thick fixed longitudinal section of the dialyzer. Average and regional blood flow velocity and wall shear rates were measured by using the reconstructed imaging sequence. The method allowed the calculation of single-fiber blood flow and single-fiber wall shear rate (SF wSh) in different regions of the hemodialyzer. In 38 patients on chronic hemodialysis, creatinine and phosphate clearance displayed a significantly negative correlation with Hct ( P  &lt; 0.05), but this correlation was not found for urea, although a trend toward reduction could be observed. The suggested explanation of this phenomenon is the significant reduction in effective plasma water flow across the hemodialyzer in presence of a progressive rise in Hct. The second explanation for this phenomenon may be found in the nonhomogeneous distribution of blood flow within the fibers observed at the sequential imaging. This, in fact, could also explain the negative trend observed for urea. At higher Hct levels, single-fiber blood flow velocity and SF wSh were significantly lower in the fibers situated at the periphery of the bundle. At the same time, SF wSh tended to decrease in peripheral fibers, showing a value near half of that observed in the central fibers of the bundle (165  versus  301 s −1 ). A similar technique was used to study the flow distribution in the dialysate compartment in three different types of hemodialyzers with characteristic dialysate compartment design: (A) standard configuration; (B) space yarns (spacing filaments preventing contact between fibers); and (C) Moiré structure (wave-shaped fibers to prevent contact between adjacent fibers). Clinical sessions of hemodialysis were also carried out to measure blood- and dialysate-side urea clearances in the different hemodialyzers. Macroscopic and densitometric analysis revealed that flow distribution was most homogeneous in the dialyzer with Moiré structure (type C) and least homogeneous in the standard dialyzer (type A). Space yarns (type B) gave an intermediate dialysate flow distribution. Urea clearance ( P  &lt; 0.001) increased significantly with types B and C, compared with the standard dialyzer. Type C had the highest clearances, although they were not significantly greater than type B. In conclusion, a significant blood-to-dialysate flow mismatch may occur in hollow-fiber hemodialyzers due to either uneven blood flow distribution or a dialysate channeling phenomenon external to the fiber bundle. Improvement in dialyzer design may overcome these problems, at least in part.

Blood and Dialysate Flow Distributions in Hollow-Fiber Hemodialyzers Analyzed by Computerized Helical Scanning Technique