English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This work presents the experimental results of the facing turning of an Al-Mg alloy. This aluminium alloy was mechanically and metallurgically modified, by means of cold rolling reduction and refining grain size previous to machining. The samples were cut and compared with samples in the as-received form, machined under the same cutting conditions. Surface finishing and work hardening were measured. Results show that theoretical surface roughness values are always smaller than the measured ones for all samples. Also, the surface roughness of the as-received samples is larger than that of mechanically modified samples. This difference of surface roughness was attributed to the swelling effect of the material. Microhardness values of the machined samples showed a decreasing trend with increasing loads. The surface of the cold rolled sample did not present a detectable microhardness alteration. Optical microscopy was used to observe qualitative aspects of the machined surface

Influence of the mechanical and metallurgical state of an Al-Mg alloy on the surface integrity in ultraprecision machining