English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

A series of linear low-density polyethylene (LLDPE)-natural rubber (NR) blends of composition 80/10, 70/20, 60/30, 50/40 and 40/50 containing nano-sized fillers montmorillonite (MMT) and Titanium(IV) Oxide (TiOâ‚‚) were produced by a twin-screw extruder with maleic anhydride grafted linear low-density polyethylene (LLDPE-g-MAH) of 10 wt% as a compatibilizer. An electrical performance test through partial discharge (PD) characteristics using CIGRE Method II test was conducted to study the electrical performance of the samples. Applied voltage was set on 7kVrms for 1 hour. The discharge characteristics were observed using picoscopeâ„¢ and LabViewâ„¢ programming. Morphological analysis using scanning electron microscope (SEM) was also conducted after the sample of composite was subjected to high voltage stress. The degradation of composite surface was analyzed. Then tensile test carried out to investigate the mechanical performance of the composites. The combine results of PD characteristics and tensile properties described the insulating performance of the composites. The results revealed that total PD numbers decrease with increasing of weight percentages of natural rubber in the composition of the composite without any filler. In addition, it is found that total PD numbers significantly decreased on sample with MMT filler compared to TiOâ‚‚ one.

Partial Discharge Characteristics with Morphological Analysis and Tensile Properties of Linear Low-density Polyethylene-Natural Rubber Blends