English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this study, Cr3C2-NiCr cermet coating samples were prepared by atmospheric plasma spraying (APS) technique on 410 stainless steel substrate with different plasma spraying parameters, namely, the powder feed rate (10 and 30 g.min -1 ) and the plasma current (500 and 600 A). The erosion-corrosion behaviour of the coatings was studied by electrochemical measurements, salt spray and erosion-corrosion tests. The electrochemical tests were performed in 3.5 wt.% NaCl solution. During the erosion-corrosion test, the samples were immersed in 3.5 wt.% NaCl solution containing 0.25 wt.% SiO2 particles with a rotational speed of 950 rpm for 72 hours. The obtained results showed that the plasma sprayed coating sample at the plasma current of 600 A and the powder feed rate of 10 g/min has a best erosion-corrosion resistance. Red rust spots did not appear on surface of this coating after 120 hours of salt spray test. It was much slower than on the others (after only 24 hours salt spray test). The weight loss of this coating during the erosion-corrosion test was lower than the remaining samples. These results are consistent with the results of electrochemical tests.

A STUDY ON EROSION AND CORROSION BEHAVIOR OF Cr3C2-NiCr CERMET COATINGS