English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Plutonium (Pu) is one of the primary actinides of concern for long-term disposal and storage of nuclear waste. Strong sorption of Pu onto colloids of iron oxide, clay, and silica could result in colloid-facilitated transport of this actinide in groundwater systems. However, fundamental data on Pu sorption to colloids is sparse, resulting in large uncertainties in long-term predictions of colloid-facilitated Pu transport. This sparseness of data and the potential to significantly reduce uncertainties in predictive models served as a motivation for this study. The authors investigated the sorption and desorption behaviors of  239 Pu(V) on three types of inorganic colloids (hematite, montmorillonite and silica), with adsorption being measured as a function of temperature, ionic strength and colloid concentration for each colloid. Natural ground water collected from Well-13 near Yucca Mountain, Nevada, and synthetic ground water (SYN.J-13) were used in the experiments. The results indicated that the adsorption of  239 Pu(V) onto hematite colloids was faster and had a higher partition coefficient ( K  p , ml g -1 ) than onto montmorillonite or silica colloids in both J-13 and SYN.J-13 waters. Temperature did not significantly influence the adsorption of  239 Pu(V) onto hematite and silica colloids, but the adsorption of  239 Pu(V) onto montmorillonite colloids increased significantly with increasing temperature. While ionic strength did not significantly influence the adsorption of  239 Pu(V) onto hematite colloids, an increase in ionic strength decreased the adsorption of  239 Pu onto montmorillonite and silica colloids. Adsorption of  239 Pu(V) per unit mass of colloid was much higher at low colloid concentrations than at high colloid concentrations. Desorption of  239 Pu from  239 Pu-loaded colloids was considerably slower than the adsorption process.

Sorption kinetics and impact of temperature, ionic strength and colloid concentration on the adsorption of plutonium-239 by inorganic colloids