English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Polyamide-imide (PAI) polymer is a high-temperature resistant polymer, which is used as contact breaker material because of its high electrical insulation property. The working conditions of contact breakers arise from the wear and friction problem conditions of these materials. Therefore, the tribological behavior of PAI polymer is important. In this study, the friction and wear performance of pure PAI polymer and PAI composite [PAI+12% graphite+3% polytetrafluoroethylene (PTFE)] were studied in two different cooling environmental conditions (with and without air cooling). Wear tests were carried out with the configuration of a polymer pin, on a rotating AISI 316 L stainless steel disc. Test conditions were atmospheric conditions, 50 N, 100 N, and 150 N loads and 0.5, 1.0, 2.0 and 3.0 m/s sliding speeds. For sliding without air cooling and sliding with air cooling, the results show that the coefficient of friction and wear rates for pure PAI and PAI+12% graphite+3% PTFE composite, slightly decrease and increase with the increase in applied load and sliding speed values, respectively. In addition, for the range of loads and sliding speeds of this study, low coefficients of friction and high specific wear rates are registered at sliding under air cooling conditions. Finally, the wear mechanism includes adhesive and abrasive processes.

Tribological performance of industrial polyamide-imide and its composite under different cooling conditions