English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

A large number of metal parts specific to the aviation, energy, and biomedical industries are produced by the electron beam melting (EBM) method, which is one of the powder bed additive manufacturing techniques. The limited build volume of EBM machines does not allow the production of parts in the desired dimensions. One way to overcome this limitation is to weld small size additive manufactured parts. In this study, EBMed Ti6Al4V tensile specimens were joined by laser (LBW) and tungsten inert gas (TIG) welding. Welding morphologies, microstructures, and mechanical properties of joints were investigated. The main defects in the samples are pore formation and insufficient penetration. The weld zones of TIG samples contain a higher amount of pores than laser samples, and these pores are distributed over the entire area of the weld. The pores are less than 200 µm in diameter. TIG welded samples exhibited higher mechanical properties than laser welded samples. The highest microhardness was measured in the weld zone. Microhardness of laser welded samples are higher than TIG welded samples. While the welding regions of TIG welded samples consist of coarse and acicular α and α + β structures, laser welded samples consist of thin and acicular α′ structure.

Comparison between laser and TIG welding of electron beam melted Ti6Al4V parts