English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

The objective of this study was to investigate how a stress wave travels in a standing tree as it is introduced into the tree trunk through a mechanical impact. A series of stress wave time-of-flight (TOF) data were obtained from three freshly-cut red pine ( Pinus resinosa  Ait.) logs by means of a two-probe stress wave timer. Two-dimensional (2D) and three-dimensional (3D) stress wave contour maps were constructed based on the experimental data using a commercial software. These stress wave contour maps represent the wave fronts in a time sequence, illustrating the flow of stress wave energy within a log. The analysis of TOF data and wave fronts indicates that stress wave propagation in standing trees is affected by tree diameter, travel distance, and internal wood conditions (wood properties and structural defects). When a stress wave is introduced into a tree trunk from a point source, it initially propagates in the impact direction as a 3D wave. Then the flow of the stress wave energy gradually changes towards the longitudinal directions. As the diameter-to-distance ratio reaches 0.1 or below, the wave begins to travel as a quasi 1D wave.

Experimental investigation of stress wave propagation in standing trees