English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Many studies have successfully applied near infrared (NIR) spectroscopy to estimate important wood traits. Some of them have reported the effects of wood surfaces on NIR spectra information and their influence on the performance of the predictive model. However, limited information is available concerning the effect of sample preparation on the model performance to estimate chemical properties in  Eucalyptus  wood. Hence, the aim of this study was to investigate the influence of the milling procedure, particle size, and quality of the solid wood surface on the performance of the partial least squares regression to predict chemical properties of  Eucalyptus urophylla  wood by NIR spectroscopy. Adequate models were built to predict klason lignin content, acid-soluble lignin content, and syringyl-to-guaiacyl ratio in  Eucalyptus urophylla  wood. Sample preparation strongly influences the ratio of performance to deviation (RPD) of these predictive models. The effect of the sample presentation (solid or milled wood) was stronger than the effect of the particle size difference between thin and thick powder. The best calibrations were developed using NIR spectra measured on wood powder (RDP values from 1.99 to 2.97), but satisfactory calibrations were developed from NIR spectra measured on solid samples (RPD values from 1.68 to 2.16).

Effects of sample preparation on NIR spectroscopic estimation of chemical properties of Eucalyptus urophylla S.T. Blake wood