English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

Wood density measurement is related to several factors that influence wood quality. In this paper, a CT image calibration procedure which allows image quantification in terms of dry bulk density is presented for three different X- and gamma-ray energies (28.3, and 59.5, and 662.0 keV). The mass attenuation coefficients measured for a set of eight wood species did not vary significantly, allowing a single calibration for determination of bulk density of air-dried wood samples at each energy. The equation for bulk density calibration obtained was validated using a second set of twelve wood species. Comparison of bulk density determined by CT images, using the calibration procedure proposed, with values obtained by gravimetric methods, presented a very good linear correlation coefficient (R 2 =0.94). The main advantage of CT imaging over conventional techniques for wood bulk density determination is that it allows detection and quantification of heterogeneities and internal defects. At the sub-millimetric spatial resolution level, it is possible to identify morphological and structural aspects of wood samples.

Wood Density Determination by X- and Gamma-Ray Tomography