English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This article studied the impacts of using different powders on the productivity of electro discharge machining (EDM) of Nimonic 8OA alloy. The powders used for experiments are chromium (Cr) and aluminium (Al), though these powders are in contrasts in their thermo‐physical characteristics. With the mixing of these powders in dielectric fluid, effect on surface roughness (SR), material removal rate (MRR), and mechanism of the machining process have been studied in this research work. On going through the results of experi‐ ments, it was observed that even volumetric proportion of powders, size of molecules, its density, electric resistance, and heat conductivity of additives were vital parameters that altogether influenced the productivity of powder mixed‐electro discharge machining (PMEDM) process. With addition of prop‐ er ratio of powders in dielectric fluid, it enhanced the material removal rate, and consequently, reduced the surface roughness. Under a similar molecule volumetric proportion tests, the minutes suspended molecule size of powder prompted the largest material removal rate and consequently, the surface roughness increased. Conclusion is that adding chromium powder improves to the highest material removal rate, but poor surface finish while adding aluminium powder has the reverse effects. © 2019 CPE, University of Maribor. All rights reserved.

Effect of aluminium and chromium powder mixed dielectric fluid on electrical discharge machining effectiveness