English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

To investigate the influence of the WC and Co contents, the cutting of five kinds of cemented carbides was carried out with the PCD tool. Moreover, one of them was the cemented carbides whose binder was Ni, and the influence of the binder was also found out. The tool wear width and the cutting forces were measured, and the worn flank was observed. Summary of results are shown as follows. (1) The tool wear didn’t always increased with increase of the Co content. (2) Not only the WC content but also the WC particle diameter influenced the tool life. (3) The adhesion could be found out in cutting every cemented carbides regardless of the content and composition. (4) The thrust forces were concerned with the flank wear.

Influence of WC and Co Contents in Cutting of Wear and Impact Resistant Cemented Carbides