English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this study, the residual stresses in high-density polyethylene (HDPE) and a fiber reinforced polyethylene was measured using an x-ray stress measurement technique. There have been few reports published of residual stress investigations in polymeric materials by x-ray stress measurements based on conventional x-ray reflection methods. There are two problems associated with this measurement. Firstly, the diffraction peaks of the polymer appear in the low 2θ angle region and therefore the measurement accuracy for strains reduces. Secondly, the low 2θ angle region makes it extremely difficult to use the sin2ψ method. In the present study we tried to use a transmission method for measuring the residual stress in HDPE samples to resolve these problems. The HDPE sample is shaped into thin sheets which have the three kinds of crystallinity degrees. The measured data is fitted with a good linear regression line in a 2θ-sin2ψ diagram and the gradient of the regression line corresponded to the applied stress. On the other hand, the results of the residual stress measurement are deeply associated with degrees of the crystallinity in the HDPE material. The quantitative estimation of crystallinity degrees in the HDPE material was accomplished by a sink-float method. The residual stress distributions were discussed between micro-residual stresses in the crystal phase of HDPE with the amorphous phase of it. Finally, x-ray elastic constant (XEC) of HDPE was estimated and the residual stresses in the fiber reinforced polyethylene was also measured by use of this XEC parameter.

X-ray Residual Stress Measurement of Fiber Reinforced Plastic Composite