English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Software for correcting the dynamic error of the force sensor in the impact force measurement, which uses an output signal of the sensor itself, has been improved. The software corrects the output waveform of the sensor by using the output waveform itself and estimates its uncertainty. In the experiment, the dynamic error of the sensor is evaluated using the Levitation Mass Method (LMM). In the LMM, the impact force applied to the sensor is accurately determined as an inertial force of the moving part of the aerostatic linear bearing. The parameter for correcting the dynamic error is determined from the results of one set of impact measurements of the sensor. Then the validity of the parameter is evaluated by using the results of measurements of the sensor. The uncertainty of the un-corrected force and that of the corrected force are also estimated. In the previous version of the software, the user input “input text-file” which contains force that is calculated based on the static calibration results. On the other hand, the output signal from the sensor is not force. This time, the software has been modified to load input text-file which contains the output signal from the sensor.

Improvement of Software for Dynamic Force Correction of Force Transducers