English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Magnesium based alloy containing 9 wt. % Li, 1,5 wt. % Al, composed of alpha + beta (hcp + bcc) phases was cast under argon atmosphere and extruded at 350 degrees C as bars of cross section 12x12 mm. Twist Channel Angular Pressing TCAP deformation was applied at a temperature of 160 degrees C using BC rotation of samples in the following passes. TCAP tool consisted of helical part in horizontal area of the channel with an angle of lead gamma = 30 degrees to simulate back pressure and thus to increase the extrusion force. The initial grain size of the hexagonal. phase estimated at 30 mu m decreased in the following passes down to 6 mu m and that of bcc. phase decreased after TCAP from initial 12 mu m, down to 5 mu m. TEM studies after TCAP passes showed higher dislocation density in the. region than in the alpha phase. Crystallographic relationship (001) alpha || (110) beta indicates parallel positioning of slip planes of both phases due to activation of slip. Electron diffraction indicates increase of grain misorientation with a number of TCAP passes. Stress/strain curves measured at temperature of 200 degrees C show superplastic forming after 1st and 3rd TCAP passes with better superplastic properties with increasing number of passes. Values of strain rate sensitivity coefficient m were calculated at 0.31 after 1 TCAP pass using flow stress values from step strain increase curves. The sample after 3 TCAP passes showed increase of m value up to 0.47 for the strain rate range 10(-5)-5 x 10(-4) s(-1). Obtained values are slightly lower than those reported in the literature, however increase of a number of TCAP passes has a positive effect on superplastic properties due to fine grains and increase of their misorientation

SUPERPLASTIC DEFORMATION OF TWO PHASE MgLiAl ALLOY AFTER TCAP PRESSING