English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Corrosion of reinforcement is one of the most common causes of deterioration in reinforced concrete bridges. Anchorage, prior to shear and bending moment resistance, is the main uncertainties in the evaluation of the structural behavior of corroded reinforced concrete bridges. Thus, to assess the remaining load-bearing capacity of deteriorated existing bridges, models to estimate the remaining bond and anchorage capacity are needed. Most of our knowledge on the structural behavior of corroded reinforced concrete structures is based on experimental investigations of artificially corroded concrete specimens. In this study, the anchorage capacity of naturally corroded steel reinforcement was investigated experimentally. The test specimens were taken from edge beams of a bridge, Stallbackabron, in Sweden. Since the dimensions and the amount of reinforcement were given on beforehand, it was only the test set-up which could be chosen freely. A test set-up consisting of a four point bending test indirectly supported with suspension hanger was considered to be the best alternative with the least disturbance and influence of the natural damages. Detailed design was done by using a non-linear finite element method. It was seen that the edge beams needed to be strengthened with transverse reiforcement, else they would have failed in a local failure at the suspension hole or in shear. The technique adopted for the strengthening was an internal mounting of steel reinforcement using epoxy as adhesive. The bond and anchorage behavior was examined in tests through measurements of applied load, free-end slip and mid-span deflection. A first test showed that additional measures were needed to ensure anchorage of the strengthening bars. In subsequent tests, they were therefore anchored at the top of the beam with hexagonal nuts and flat steel plates. In two following tests, the beams failed in a splitting induced pull-out failure, i.e. anchorage failure was achieved as wanted.

Anchorage capacity of naturally corroded reinforcement in an existing bridge