English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this study was analyzed the behavior of one transistor called UTBOX (Ultra Thin Buried Oxide) FD SOI MOSFET (Fully Depleted Silicon-on-Insulator MetalOxide-Semiconductor Field-Effect-Transistor) working as a 1T-FBRAM (Single Transistor Floating Body Random Access Memory). This memory device is an evolution from conventional memories 1T1C-DRAM, however formed by only one transistor, the device itself is responsible for the storage of the information through the floating body effect. Thus two dimensional simulations were performed, where were obtained dynamic curves, and from these curves it was possible to extract and analyze some of the main parameters, such as, trigger drain voltage, sense margin current, read window, and the retention time, beyond the mechanisms in each state of memory (write, read and hold). Among the possible ways to program the data ‘1’ in this technology were used the methods GIDL (Gate Induced Drain Leakage) and BJT (Bipolar Junction Transistor). By the GIDL method it was possible to operate the memory cell at high speed without spending significant power, showing that this method is very promising for low-power high-speed. Furthermore, greater stability was obtained in read operation when it is biased at point ZTC (zero-Temperature Coefficient) due to the current level of datum '0' remain stable even with temperature variation. By the BJT method, it was studied the influence of the silicon film thickness and the buried oxide thickness, and it was noted a strong dependence on minimum drain voltage for programming the data '1' as a function of both thicknesses. As the thickness of the silicon film becomes thinner, the trigger drain voltage increases due to stronger coupling. However, it was observed that the level of the trigger drain voltage can be modulated by the substrate bias in this way it is possible to operate the cell with lower voltage avoiding the damage and increasing the lifetime of the device. About the temperature, with its increase it was observed that the minimum drain voltage required to trigger the writing datum '1' decreased favoring the programming the cell. However the retention time is harmed (becomes smaller) due to the increment of leakage current in the PN junction. Analyzing the impact of the first and second gate on sense margin current and retention time, it was verified that depending on the voltage applied to the gate during the hold condition, the retention time may be limited by the generation or recombination of the carriers (holes). It was noted that there is a compromise between obtaining the best sense margin current and the best retention time. Since the retention is the most critical parameter, more attention should be given in order to obtain the optimization of this latter. It is concluded in this analysis that the best bias to retain the datum for longer time is the first interface being in accumulation mode and the second in depletion mode. In the study of biasing the drain during the read operation, it has been observed that the use of high drain voltage provides high sense margin, but at the same time, this polarization affect the data '0' due to high level of holes generation induced by impact ionization, which shortens the retention time and destroys the data '0' in multiple read operations. However, for low drain voltage during read operations it was possible to perform multiple read operations without losing the stored data and also higher retention time was obtained.

Estudo de célula de memória dinâmica de apenas um transistor SOI de óxido enterrado ultrafino.