English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The aim of this study was to evaluate bond strength of self-etching and total-etching adhesive systems to dentin of first and second primary molars and to analyze the adhesive interface under scanning electron microscopy. Dentin samples pulp distant 35% to 65% (intermediate dentin) were obtained from buccal and lingual surfaces at the middle third of the crown of 108 primary molars by sectioning with a diamondimpregnated disc under water cooling. Dentin surfaces were polished with 400 and 600-grit silicon carbide paper under running water. Five adhesive systems were tested on the first and second primary molar surfaces (n=15/group): Adper Single Bond; Prime & Bond NT; AdheSE; Clearfil SE Bond; Adper Prompt L-Pop. Inverted, truncated cones of resin composite (Filtek Z250) were built with a 2.0 mm bonding diameter. After 24-hour storage in distilled water at 37°C, the specimens were submited to the tensile test at a crosshead speed of 0.5 mm/min. To analyze adhesive interface 50 samples were prepared with the same protocol described above (n=5/group). No differences between first (16.02±5.23 MPa) and second (16.03±5.05 MPa) primary molars bond strength values could be observed (ANOVA:P=0.2721). Bond strength mean values registered in MPa obtained were 14.32±3.57 (Adper Single Bond), 15.65±3.70 (Prime & Bond NT), 19.47±7.09 (AdheSE), 17.14 ±5.35 (Clearfil SE Bond) and 14.22±3.20 (Adper Prompt L-Pop). AdheSE adhesive system presented the greatest bond strength values statistically different to the other groups (Tukey=3.47), while no statistically significant difference was observed for Clearfil SE Bond. In the other comparisons no differences were found. Scanning electron microscopy analysis showed the presence of hybrid layer and tags in all adhesive systems on both dentin types.

"Estudo comparativo da resistência de união e da interface entre sistemas adesivos e a dentina de molares decíduos humanos"