English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Spatial light modulators perform the modulation of wavefront so that the desired light distribution is acquired. They work by diffraction, according to the Huygens-Fresnel principle, and for that they are called Diffractive Optical Elements (DOEs). The focus of this work is the study of light modulators through Scalar Diffraction Theory. The initial objective was to execute the calculation of spatial light modulators through the implementation of the so-called Iterative Fourier Transform Algorithm. The calculation of three phase holograms is made: analog phase, 4 level phase and binary phase. The results are evaluated by calculating the diffraction efficiency and by signal to noise ratio. To verify the calculation, binary holograms were fabricated using photographic film in a simple and low cost way. Simulated and optical reconstructions are presented, showing the viability for the use of the algorithm in the coding of DOEs. Next, the resonance frequencies analysis in open tubular channels ferroelectrets is made through an experimental setup based in the Michelson interferometer. The ferroelectrets present the piezoelectric effect and are continuously produced through new techniques. In optics there is in interest in feroelectrets characterization in order to use them as spatial light modulators. The interferometric setup and the procedure used to measure the resonance frequencies are shown. The obtained results and discussion demonstrate the viability of the use of optical measurements in the characterization of ferroelectrets.

Aplicação da óptica escalar na modulação de frentes de onda e em medidas de ressonância de moduladores de ferroeletretos