English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Tools annual

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Presents the access of premium content as premium feature

Premium Content

Global: Zendy Plus annual

Global: Zendy Free Plan

Laser velocimetry measurements were taken in a double volute/single discharge centrifugal pump (0.60 specific speed, 1583US units) with symmetrical volute halves. Blade-to-blade radial and tangential velocity profiles at the impeller exit arepresented and compared to data for a similar single volute pump. Flow rates ranged from 40% of design flow to the designpoint. The blade-to-blade profiles were more uniform than for the single volute pump. Also, the average circumferentialvariations for the double volute pump were more symmetric than for the single volute pump. For the double volute geometrymeasurements indicate that radial inward flow (recirculation) was only present for flow rates below 60% of design flow,compared to 80% of design flow for the single volute pump. Velocity data was also used to determine volute losses, slipfactor, and momentum contributions to the impeller radial forces. Volute losses were quantified and shown to increase forflow rates below 80% of design flow and were approximately 10% of the developed head at 40% flow. The efficiency inthe double volute compared to the single volute shows decreased performance for flows above 55% of design flow, whichis attributed to increased boundary layer friction; at low flow rates increased performance is ascribed to better control overthe recirculation regions. Slip factors were symmetric around the volute but were lower than for a single volute pump.Finally, momentum contributions to the total impeller radial load were shown to be maximum at the design point,contributing 40% of the force developed by the pressure distribution; the significance diminished at lower flow rates andthe contribution was negligible at 40% of the design flow

Laser Velocimetry Measurements in a Double Volute Centrifugal Pump