English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Stability of a high-speed craft is an essential matter, and porpoising is one of the most critical instabilities that could occur in some planing hulls due to inappropriate design. In this paper, the porpoising phenomenon and variation of step location yielding resistance reduction are studied through experimental and numerical methods. The investigated models include a single-step model and a nonstep model with the same general shape, but with different step location. The nonstep model is previously tested, but the single-step model is examined in the present study. The nonstep model experiences porpoising at 8 m/s speed, but the single-step model remains stable at the same speed. A three-dimensional CFD analysis is conducted using the finite volume method (FVM). On the contrary, the volume of fluid (VOF) scheme is used for free surface modeling, and the overset mesh technique is implemented within StarCCM+ software. The CFD results of total hydrodynamic resistance and dynamic trim angle are compared against the experimental data. The numerical results are in good agreement with the experimental data. Subsequently, ten different stepped models are simulated to examine their effects. The longitudinal distance between steps and aft of these models are in the range of 19 to 50 percent of the length of models. The obtained results show that as steps are located farther than aft, the models become more stable, and resistance increases due to trim reduction. Finally, the optimum location of the step is extracted with the aim of minimizing the resistance through the design of experiment (DOE) method. Based on the DOE method, it is observed that the sensitivity of the drag value to the step location is higher than the speed.

Experimental and Numerical Investigation of Stepped Planing Hulls in Finding an Optimized Step Location and Analysis of Its Porpoising Phenomenon