English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

In this study, we examined the effects of different temperatures and accelerators on the gelation (gel) time and compressive strength of a Polyethylene Terephthalate (PET)-type unsaturated polyester resin anchorage agent. First, the formation temperature of 20–70°C was simulated using self-made test equipment. N,N-Dimethylaniline (DMA), N,N-dimethylp-toluidine (DMT), and hydroquinone were selected as accelerators to determine gel time and heat release peak. The gel time of an anchorage agent is strongly influenced by accelerant and temperature. When DMT, DMA, and hydroquinone were added at the same temperature, the gelation time increased; with increasing ambient temperature, the gelation time of the anchorage agent decreased. The peak exothermic value of the curing reaction was less affected by the accelerator, and the peak exothermic value of the anchoring agent increased with the increase in ambient temperature. Then, the compressive strength of the anchorage agent, maintained at 20, 50, and 80°C for 1.5, 6, 12, and 24 h, was measured. We found that the compressive strength of resin anchorage agent decreased significantly with the increase in temperature, and the addition of DMT can improve the compressive strength of resin anchorage agent slightly at the same temperature conditions. Finally, through Fourier transform infrared scanning analysis, we determined the intrinsic causes of the influence of temperature and accelerator on the gelation time and compressive strength of the anchorage agent. Through SPSS fitting analysis, an empirical formula for predicting gelation time based on ambient temperature is proposed. Our findings provide a basis for reasonable mixing time and support design optimization of anchorage support in deep stratum in high-temperature geothermal environments.

Effect of Temperature and Accelerator on Gel Time and Compressive Strength of Resin Anchoring Agent