English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Mechanical ball milling assisted by sintering in the solid state was used in this research to produce the Zn-Nix system alloy. The derivative powder compositions of Zn-Nix (x = 0, 5, 10, 15, and 20 wt.%) were obtained to study the Ni effects on the microstructural and mechanical properties. It is worth remarking that conventional methods are not appropriate for the manufacture of the Zn-Nix system alloy. The morphological structure and phases were examined by optical microscopy, X-ray diffraction, and SEM/EDS elemental mapping, whereas the mechanical behavior was accomplished by means of a diamond indentation print (Hardness Vickers). The results showed that the intermetallic γ-ZnNi phase did not form during milling time (<4 h); it appears after the sintering process, which is associated with atomic diffusion mechanism through grain boundary at the minimum interfacial energy (ΔG256°C = −13.83 kJ·mol−1). The powder Zn-Ni10 was found to have better properties. Semispherical coarser particles were seen into the metal matrix (Zn δ-hcp structure) as segregates; however, each particle contains an intermetallic compound Zn-Ni that encloses the Ni (α-fcc structure) pure phase. The Ni-α phase was then transformed into a γ-ZnNi intermetallic compound which shifts to higher values of mechanical hardness from about 60 HV to 400 HV units.

Synthesis and Characterization of Zn-Nix Advanced Alloys Prepared by Mechanical Milling and Sintering at Solid-State Process