English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Y2O3 nanoparticle suspension aqueous solution was prepared using citric acid. Then, Y2O3 film was deposited using this solution with pulsed electrophoretic deposition (EPD). A dense Y2O3 film of 25.7 μm thickness was obtained with deposition conditions of 0.5 wt% Y2O3 concentration, bias voltage of 0.5 V, and bias frequency of 1 kHz. The respective resistivities of the as-deposited film and films heat-treated at 200°C and 400°C were 2.84 × 103 Ω·cm, 5.36 × 104 Ω·cm, and 2.05 × 106 Ω·cm. A 59.8 μm thick dense Y2O3 film was obtained using two-step deposition with change of the bias voltage: a first step of 0.5 V and a second step of 2.0 V.

Influence of Deposition Condition on Y2O3 Coatings Produced by Pulsed Electrophoretic Deposition