English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

Attempts were made to characterize and optimize the novel oxide-free insulated gate structure for InP, having an ultrathin Si interface control layer (Si ICL). An in situ X-ray photoelectron spectroscopy (XPS) study indicated that P deficiency took place on the InP surface by the irradiation of a high-energy Si beam during the MBE growth of Si ICL. Based on this, a modified gate structure having an In0.53Ga0.47As cap layer on the InP surface for prevention of phosphorus loss was proposed and its interface properties were investigated. A careful design for quantum state control indicated that the Si ICL thickness should be reduced down to 0.5 nm for the InGaAs cap thickness of 3 nm. In situ XPS spectra showed that no pronounced desorption of As or P took place from the surface in the new gate structure. In situ contactless C-V measurement showed a low and wide interface state density distribution with a minimum of 2×1011 cm-2eV-1. An InP MISFET test device with a gate length of 2 μm exhibited a maximum gm of 123 mS/mm and a high drain current of 389 mA/mm. These results indicated the effectiveness of the novel oxide-free insulated gate structure for application to InP power MISFETs as well as to surface passivation

Optimization and Interface Characterization of a Novel Oxide-Free Insulated Gate Structure for InP Having an Ultrathin Silicon Interface Control Layer