English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Distortion-product otoacoustic emissions (DPOAE) are measured by stimulating the ear with two simultaneous tones. A novel method for measuring DPOAEs has been developed in which the tone levels vary continuously instead of in discrete steps. Varying the tone levels continuously may offer advantages for characterizing DPOAE level as a function of stimulus level. For equivalent primary levels, DPOAE levels measured with the continuous-level method were the same as levels obtained with the discrete-level method, thus validating the new method. Continuous-level measurements were used to determine the optimal L1 for each L2 in individual subjects (N= 20) at f2 = 1, 2, 4, and 8 kHz by using a Lissajous path that covered a wide range of stimulus levels. The optimal L1 (defined as the L1 that resulted in the largest DPOAE for each L2) varied across subjects and across frequency. The optimal difference between L1 and L2 decreased with increasing L2 at all frequencies, and increased with frequency when L2 was low. When the optimal L1 was determined individually for each ear, the DPOAE levels were larger and less variable than those obtained using the equation for L1 suggested by Kummer et al. [J. Acoust. Soc. Am. 103, 3431-3444 (1998)].

Distortion-product otoacoustic emission measured with continuously varying stimulus level