English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

This paper proposes a co-design optimization procedure of a high-power off-board charger for electric vehicle (EV) applications. The primary purpose is to design a 175 kW SiC DC-charging system with high power density to achieve high efficiency at a wide operating range. For the active part of the DC off-board charger, a three-phase active front end (AFE) rectifier topology is considered in the design optimization and the modelling. The design methodology focuses on the optimal design of the passive filters, accurate electro-thermal modelling of the converter, inductor design, capacitor selection, loss and geometric modelling of the passive filters and control system design. The design optimization of the high-power charging system is performed in MATLAB Simulink using a closed-loop dynamic electro-thermal simulation of the off-board charger. The switching frequency, loss and temperature-dependent efficiency of the charger is investigated in parallel. Through this proposed technique, efficiency greater than 96% is achieved at a switching frequency of 40 kHz, along with a smaller size and lower weight of the system. Moreover, it operates with a current total harmonic distortion (THDi) below 3% and a power factor (PF) above 99% at rated power condition.

Design Optimization and Electro-Thermal Modeling of an Off-Board Charging System for Electric Bus Applications