English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

An alumina-toughened zirconia (ATZ) material, fabricated using a procedure consisting of the common sintering of two different zirconia powders, was tested using the ball-on-disc method in a temperature range between room temperature and 400°C. Tetragonal zirconia balls were used as a counterpart. Two different types of microstructure were designed, one consisting of separated alumina inclusions in a zirconia matrix and another one which was a combination of two continuous phases, penetrating the whole volume of the composite. It was detected that at elevated temperatures both materials showed a distinct decrease in the wear rate. Composite with a low alumina content showed minimal wear rate at 300°C and composite with higher amount of alumina showed it at 400°C. There are some observations that this minimal wear rate result is connected with a pseudoplastic behaviour of a layer formed between co-operating elements of tribological pair. This layer is composed of the debris of both, sample and counterpart, and its behaviour during sliding is connected with the mean grain size of this debris which is correlated with the mean grain size of sintered material.

Wear behaviour of alumina-toughened-zirconia composites with different phase arrangement under ball-on-flat tribological tests