English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Photopolymer resins are applied at an increasing rate in additive manufacturing (AM) industry as vat photopolymerization (VP) and material jetting (MJ) methods gain more popularity. The aim of this study was to measure volatile organic compound (VOC), carbonyl compound, ultrafine particle (UFP), and particulate matter (PM 10 ) air concentrations emitted in 3D printer operations. Individual chemicals were identified when multiple photopolymer resin feedstocks were used in various VP and MJ printers. The size distributions of UFPs, and indoor air parameters were also monitored. Finally, the VOC outgassing of the cured resin materials was determined over 84 days. The data demonstrated that 3D printer operators were exposed to low concentrations of airborne exposure agents as follows: average concentrations of VOCs were between 41 and 87 µg/m 3 , UFP number levels ranged between 0.19 and 3.62 × 10 3  number/cm 3 ; however, no impact was detected on air parameters or PM 10  concentrations. A majority of the UFPs existed in the 10–45 nm size range. The identified compounds included hazardous species included sensitizing acrylates and carcinogenic formaldehyde. The outgassed products included similar compounds that were encountered during the AM processes, and post-processing solvents. Products heated to 37°C emitted 1.4‒2.9-fold more VOCs than at room temperature. Total emissions were reduced by 84‒96% after 28 days roughly from 3000–14000 to 100–1000 µg/m 2 /hr. In conclusion, resin printer operators are exposed to low concentrations of hazardous emissions, which might result in adverse health outcomes during prolonged exposure. Manufactured resin products are suggested to be stored for 4 weeks after their production to reduce potential consumer VOC hazards.

Organic compound and particle emissions of additive manufacturing with photopolymer resins and chemical outgassing of manufactured resin products