English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

The laminar-turbulent transition in an incompressible flat-plate boundary layer was studied experimentally by using a spanwise array of computer-controlled surface heating elements to generate small disturbances. Oblique Tollmien-Schlichting waves were successfully introduced, and their downstream development into the intermittent region was studied using flush-mounted hot-film wall-shear sensors and dye flow visualization. Comparative studies of the development of single oblique waves were made for various wave angles, frequencies, and amplitudes. As these single oblique waves grew and began to break down, higher harmonics and subharmonics appeared in the wall shear. The amplitude of the subharmonic component decreased rapidly with increasing oblique-wave angle, so that a 10 degrees oblique wave had a subharmonic amplitude an order of magnitude below that for a two-dimensional (2-D) wave. Thus, the nonlinear mechanism that produces the subharmonic is affected by the symmetry of the primary wave. Intermittency measurements, carried out farther downstream, show that a 2-D wave is most effective in moving the transition point upstream, for a given power input.

Experiments on single oblique laminar-instability waves in a boundary layer: Introduction, growth, and transition