English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Porous clay/brass composite was fabricated by an extrusion process with the addition up to 40 wt.% brass has been successfully done. Clay 80 wt.%, TiO 2  10 wt.%, active carbon 5 wt.%, and polyvinyl alcohol 5 wt.% have been prepared as a matrix for this study. All of wt.% has been mentioned excluding solvent water 20 wt.% and lubricant (glycerin oil, 1 wt.%). Before the moulding process, all the raw materials were mixed to obtain homogeneity. Blending process was done by adding 20 wt.% water until the mixture turned into dough. After the moulding process, the specimens were dried at room temperature for 48 hours, and then they were sintered at 800°C for 1 hour in an electrical box furnace with heating rate 1°C/min and holding time of 1 hour. The flexural strength of specimens and the microstructure of the sintered porous bodies were also investigated. The addition of 20 wt.% brass on the composite materials showed a higher on the strength, that is 0.6 MPa and 0.38 MPa on yield strength.

Effects of brass addition on the flexural strength and microstructure of porous clay/brass composites