English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This paper analyses the effect of the variability of metrological characteristics of a set of low-cost Micro Electro-Mechanical Systems (MEMS) for the acceleration measurement, on the calculation of typical features used for condition monitoring (CM) of automatic production lines. The knowledge of the contribution of the variability of metrological characteristics to the final accuracy of features is an aspect of interest when networks of low-cost sensors are used, in particular in case the variability of their characteristics is high. In fact, due to a mass production, the calibration is not carried out sensor by sensor, but the characteristics are determined on a sample basis and assigned to the entire batch. Neglecting the variability between sensors can lead to effects on the results of data analysis, which are not easily predictable. In this paper, the real variability of the sensor's characteristics, experimentally evaluated through the calibration of a set of 25 low-cost MEMS accelerometers, has been taken into account. Digital sensitivity, signal-to-noise ratio and data rate variability of each device have been considered for the analysis. The analysis has been carried out with reference to two different test cases of industrial interest, by modifying the real outputs of high performance piezoelectric accelerometers used for CM, in order to simulate the effect of the metrological characteristics of MEMS sensors. The results show which features, among those typically used for CM, are more affected and which characteristics of MEMS are more influencing the features themselves, with reference to the specific considered applications.

Use of MEMS sensors for condition monitoring of devices: discussion about the accuracy of features for diagnosis