English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This article discusses the problems of creating new compositions for ceramic tiles. There are two ways to process the composition of the molding material - dry and wet. A description of the wet processing method is given. The molding of the plastic mass is carried out by pressing to obtain a tile with a size of 50 x 150 mm. The molded product goes through the following stages of the technological regime: blowing in a drying stove with an increase in temperature from 25 °C to 700 °C for 3-4 hours. Further, at a speed of 15-20 degrees per minute, the temperature rises to 1050 0C and then the heat treatment continues for 30 minutes. After annealing, the product is cooled and tested.

Composition of molding material for ceramic tiles