English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This article discusses the torsion problem of a continuous cylindrical specimen used to construct a hardening curve. A brief review of the methods for processing the results of the method of torsion of a cylindrical specimen is given. The possibility of using the inverse method to determine the material model in the case of the torsion of the continuous cylindrical specimen made of steel 20H is shown. By means of QFORM 9.0 software package virtual experiment connected with torsion of a cylindrical specimen is carried out. As a result of this research, the rheological model of steel 20His determined with a high degree of accuracy. The stress-strain state of the material was analyzed during the torsion of the specimen by means of the QFORM. The results of the virtual experiment are compared with the full-scale test.Anexceptionally good match of the results was obtained. The inverse method showed its efficiency and made it possibleto determine a rheological model of the material. The model accurately describes the experimental data. The resulting material model (for steel 20H) is valid in the following range of parameters: deformation temperature of 20°C, deformation rate of 0.5 s −1 , the strain range of 0 to 2.5.

Modeling of the torsion test of a cylindrical specimen with the help of the inverse method