English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

In this paper, we present a comprehensive technique to obtain accurate three-dimensional (3D) micromachining forces for frequency bandwidths up to 25kHz. The capability to precisely measure cutting forces is central to gaining fundamental understanding on micromachining mechanics and dynamics. Multi-axis dynamometers are used to measure 3D machining forces. Forces experienced during micromachining involve very high frequencies due to the ultra-high spindle speeds used during the process. However, the specified bandwidths of the dynamometers do not meet high frequency requirements of micromachining forces; this limitation stems from the structural-dynamics response of the dynamometers. Therefore, it is important to develop approaches to compensate for the distortions arising from the dynamic effects of the dynamometer's structure in order to accurately measure micromachining forces. This paper presents a fully 3D compensation approach to enable accurate determination of 3D micromachining forces within a wide frequency range. The presented approach involves: (1) accurate identification of 3D force measurement characteristics of the dynamometer in the form of 3x3 force-to-force frequency response functions (F2F-FRFs) matrix within a 25kHz bandwidth, (2) design of an optimal inverse filter for post-processing the measured force data to remove the influence of structural dynamics of the dynamometer; and (3) validation of the compensation approach through impact testing where the actual applied force data acquired by the reference force sensor is compared with the corrected dynamometer measurements. Subsequently, the presented approach is demonstrated by obtaining 3D micromachining forces during micromilling of a brass workpiece. It is concluded that the presented approach is effective in high-frequency correction of dynamometer measurements for accurate measurement of 3D micromachining forces within the 0- 25kHz frequency range

High-frequency Compensation of Dynamic Distortions in Micromachining Force Measurements