English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

Background/purposeThe aims of this investigation were to describe the effect of different ceramic and remaining dentin thicknesses on substrate temperature during photocuring, and investigate whether the temperature increased by >5.5°C for different dentin/ceramic combinations.Materials and methodsThree groups of dentin thicknesses of 1.0 (D1.0), 1.5 (D1.5), and 2.0 mm (D2.0), and three groups of ceramic thicknesses of 1.5 (C1.5), 2.5 (C2.5), and 3.5 mm (C3.5) were examined. Temperature changes and the maximum temperature were observed under a high-intensity halogen light (QTH-Atralis 10 ECS program at 1200mW/cm2 for 30 seconds, Ivoclar Vivadent AG, Schaan, Liechtenstein). Four groups, D1.0–C1.5 (+11°C), D1.5–C1.5 (+7.2°C), D1.0–C2.5 (+6.7°C), and D2–0C1.5 (+5.8°C), demonstrated temperature changes of >5.5°C.Results and ConclusionsA statistical analysis showed that separate individual thicknesses and combinations of dentin and ceramic had significant effects on temperature changes (P<0.01). It was observed that the ceramic exhibited a smaller temperature shielding effect than dentin. Clinically, it would be optimal to preserve the dentin to avoid damaging pulp tissues. Where there is insufficient overall thickness (≤3.5mm), continuous high-energy output photocuring should be avoided to protect pulp tissues from thermal injury

Effects of different ceramic and dentin thicknesses on the temperature rise during photocuring