English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Low oil recovery which is very predominant in shale oil reservoirs has stimulated petroleum engineers to investigate the applications of enhanced oil recovery methods in these formations. One such application is the injection of gases into the formation to stimulate increased oil recovery. In many gas flooding projects performed in the field, the miscibility of the gas injected is usually the most desired displacement mechanism, and carbon dioxide (CO 2 ) gas has been recognized to be the best performing gas for injection due to its ability to be miscible with oil in the reservoir at low pressures compared to other gases such as nitrogen. This minimum miscibility pressure (MMP) is of very crucial importance because it is the primary limiting factor in the feasibility of a miscible gas flooding project. However, there are other limiting factors such as cost and availability and, in these instances, nitrogen (N 2 ) and lean gas are the more preferred candidate as opposed to carbon dioxide gas. Mixing carbon dioxide gas with lean gas or with nitrogen in a required ratio can allow us to design an injection gas that will be suitable enough to satisfy both the availability and cost constraints and at the same time allow us to achieve a reachable and reasonable miscibility pressure. The objective of this paper is to investigate the effect of mixing nitrogen gas and carbon dioxide gas in a 50:50 ratio on oil recovery in tight oil formations. The experiment was performed with controlled constraints such as the same core sample, same crude oil and same core cleaning and saturation process which was repeated for each trial. The oil used was live oil from Eagle ford formation, and the gases used were nitrogen (99.9% purity), carbon dioxide and a mixture of nitrogen and carbon dioxide in a 50:50 ratio. The injection pressure ranged from 1000 to 5000 psi with pressure increments of 1000 psi, and the same flooding time was 6 h. The potential of the N 2 , CO 2  and N 2 –CO 2  mixture for improving oil recovery was assessed along with the breakthrough time. The results showed that CO 2  gas had the highest recovery followed by the N 2 –CO 2  mixture and N 2  gas had the lowest recovery. The gas breakthrough time results showed that the N 2 –CO 2  mixture had the longest breakthrough time, N 2  had the shortest breakthrough time, and CO 2  had a significantly longer breakthrough time than pure N 2  gas. The RF increased with increasing pressure, but the gas breakthrough time decreased with increasing pressure. However, the incremental RF decreased in all three cases when the injection pressure was above 3000 psi.

Enhanced oil recovery application in low permeability formations by the injections of CO2, N2 and CO2/N2 mixture gases