English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Pro

Presents the zaia usage as premium feature

ZAIA

Presents AI Discovery search usage as a premium feature

AI Discovery

Presents AI Discovery explain and summary usage as a premium feature

Content Analysis

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Presents the pdf analysis as premium feature

PDF Analysis

1500 Top-up

3000 Top-up

Zendy Basic

2500 Top-up

Zendy Unlimited

Presents the access of premium content as premium feature

Premium Content

Ultra high strength steels are of enormous interest especially in the automotive industry due to their potential in realising light weight structures and improving the crash behaviour. However the poor formability of these steels limits their application for many parts in the car body. A solution to this limitation can be a local heat treatment using a laser beam to soften the material where a high formability is needed. Laser treatment was performed using a Nd:YAG laser with 3 kW maximum power. The output power was temperature controlled to achieve a constant temperature level during the heat treatment. Large areas are treated by scanning the surface with the laser beam. The materials under investigation are dual phase (DP), retained austenite (RA) and martensitic (MS) steels with a tensile strength of 600-1,200 MPa. The microstructure of DP steels consists of martensite and ferrite. RA steels contain ferrite, martensite and additionally a certain amount of retained austenite which transforms into martensite during plastic flow. MS steels are fully martensitic which gives them the highest yield strength of all UHS steels. The various steels were provided as not galvanised sheets (hot or cold rolled) with a thickness of 1.5 mm. Depending on material and process parameters tempering of martensite, formation of ferrite and transformation of retained austenite to martensite are observed as a result of the heat treatment. Tensile tests of DP 600, DP 1000 and MS-W 1200 reveal a significant reduction in yield and tensile strength and an increase in elongation after LHT. The effect is due to tempering of martensite and in the case of MS-W also due to an increase in volume fraction of ferrite. Tensile tests of RA-K 700 reveal a minor reduction in yield and tensile strength and a decrease in elongation. This can be attributed to the lower content of retained austenite which has transformed into martensite during LHT. From this result it can be expected that LHT is not beneficial for high deformation degrees. Deep drawing of a mock-up geometry using MS-W 1200 and RA-K 700 showed a significant decrease in slide force (*20%) compared to the initial condition. This results show that laser heat treatment has the potential to improve formability of UHS steels

Local laser heat treatment of ultra high strength steels to improve formability