English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The solidified microstructure and carbide precipitation behavior in an S390 high-speed steel processed by electron beam melting (EBM) have been fully characterized. The as-EBM microstructure consists of discontinuous network of very fine primary carbides dispersed in auto-tempered martensite matrix together with a limited amount of retained austenite. The carbide network consists of M2C/M6C and MC carbides. Both the columnar and near-equiaxed grain structures were found in as-EBM microstructure and the presence of inter-dendritic eutectic carbides assisted in revealing the dendritic solidification nature. The top-layer microstructure observation confirmed that the columnar dendritic structured grains were located adjacent to the micro-melt pool boundary, indicating an epitaxial growth with the average growth direction parallel to the maximum thermal gradient. At the center of the micro-melt pool, the near-equiaxed grains were developed by dendritic growth parallel to the beam traveling direction. The carbide decomposition was revealed by scanning transmission electron microscopy and confirmed by transmission Kikuchi diffraction. The MC carbides (rich in V followed by W) nucleated at the interface between M2C (W, Fe, Mo, and Co in the order of significance) and the matrix and then grew from the outside inward, but their nucleation might occur from the M2C carbide itself. The thermal effect induced by the adjacent scan lines seems to trigger a solid-state phase transformation of MC → M2C + γ-Fe. The elemental migration was theoretically calculated and compared with the experimental results. The high hardness of ~ 65 HRC and good transverse rupture strength of ~ 2500 MPa in as-EBM S390 means that EBM processing can be used to fabricate highly alloyed tool steels. With the help of the post-processing heat treatment, the best Rockwell hardness of 73.1±0.2 HRC and transverse rupture strength of 3012±34 MPa can be obtained.

Rapid Solidification Microstructure and Carbide Precipitation Behavior in Electron Beam Melted High-Speed Steel