English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This study seeks to improve numerical simulations of the key physics occurring in CO 2  enhanced oil recovery (CO 2 -EOR) processes, with a particular focus on the transition from immiscible to miscible displacements. In the previous work, we have investigated interactions between compositional effects and the underlying heterogeneities of the flow field in near-miscible floods (Wang et al. in Transp Porous Media 129(3):743–759, 2019a). In this current study, we have further analysed the effects of reduction in interfacial tension (IFT) on the flow behaviour, as motivated by the study on the film-flow mechanism previously presented by Sorbie and van Dijke (SPE improved oil recovery symposium, Society of Petroleum Engineers, 2010). We identify two clear mechanisms of oil recovery that may occur in near-miscible CO 2  (or other gas) injection processes, which we denote,  M  CE , as oil stripping or conventional compositional effects, and  M  IFT  as lower IFT oil film-flow effects. The latter  M  IFT  effects are described by an enhanced hydrocarbon relative permeability in the near-miscible three-phase relative permeabilities (3PRP). Various combinations between the  M  CE  and  M  IFT  mechanisms were tested by numerical simulations to evaluate the impact of each mechanism on the flow behaviour, i.e. their separate and joint effects on quantities such as the local oil displacement efficiency, phase flow vectors and the ultimate oil recovery. When acting in combination, the oil stripping and IFT effects can greatly improve the local displacement performance even when viscous fingering flow occurs. Viscous fingering is well known to lead to bypassed oil in the “non-preferential” flow paths between the main fingers. We show that the remaining oil in these non-preferential flow paths (i.e. bypassed oil) can be efficiently recovered by the combined  M  CE  and  M  IFT  mechanisms, but only with the application of water alternating gas (WAG). In contrast to oil stripping effects, the IFT effect is not dependent on continuous contact between oil and CO 2 . Instead, the remaining oil is mobilized by gas as the IFT is reduced and can be efficiently produced by subsequent water injection. This  M  IFT  mechanism has much less impact in cases with continuous CO 2  injection compared to its efficiency in WAG. This is because during continuous injection, gas fingers are dominant in the preferential flow paths, and therefore the local displacement efficiency is very good, but only in these preferential routes. On the other hand, WAG is able to make full use of the IFT effects because of its relatively stable displacing front, which allows the  M  IFT  mechanism to contribute. In this study, the effects of using different three-phase relative permeability methods were investigated and, as expected, different methods yielded different results. However, an important observation is that when IFT effects ( M  IFT ) were included, there was much less difference in the final oil recovery using the different 3PRP models; our analysis shows why this is the case.

transport in porous media

Detailed Assessment of Compositional and Interfacial Tension Effects on the Fluid Behaviour During Immiscible and Near-Miscible CO2 Continuous and WAG Displacements