English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Densities of two methane-rich binary mixtures were measured in the homogeneous liquid and the supercritical region at temperatures between (100 and 160) K using a low-temperature single-sinker magnetic-suspension densimeter. For each mixture, four isotherms were studied over the pressure range from (0.3 to 10.8) MPa. Molar compositions of the gravimetrically prepared methane-rich binary mixtures were approximately 0.01 butane and 0.02 isopentane, respectively, with the balance being methane. The relative expanded combined uncertainty ( k  = 2) of the experimental densities was estimated to be in the range of (0.02 to 0.06) %. Due to a supercritical liquefaction procedure and the integration of a special VLE-cell, it was possible to measure densities in the homogeneous liquid phase without changing the composition of the liquefied mixture. Based on the supercritical liquefaction procedure, a new time-saving measurement procedure was developed and applied. Moreover, saturated-liquid densities were determined by extrapolation of the experimental single-phase liquid densities to the vapor pressure calculated with an equation of state (EOS); here, the relative expanded combined uncertainty ( k  = 2) is less than 0.05 % in most cases. The new experimental results were compared with the GERG-2008 equation of state, the EOS-LNG and the enhanced revised Klosek and McKinley (ERKM) method.

international journal of thermophysics

Density Measurements of (0.99 Methane + 0.01 Butane) and (0.98 Methane + 0.02 Isopentane) over the Temperature Range from (100 to 160) K at Pressures up to 10.8 MPa