English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The article covers experimental research on the forming of products made of 7075 aluminum alloy. This aluminum alloy grade is characterized by high strength, but due to its low formability in T6 temper, its use in the stamping processes of complex structural elements is limited. The authors have manufactured a U-shaped element at an elevated temperature and determined the optimal parameters of the process. Conventional heating of the sheet and shaping it at the temperature of 100 and 150 °C allowed to obtain a product of high strength similar to the T6 state, above 540 MPa. Due to the excessive springback of the sheet during forming, these products were characterized by a large deviation of the shape geometry, exceeding the allowable values of + / − 1 mm. Only the use of an alternative method of heating the sheet to temperatures of 200 and 240 °C (between plates at 350 °C, heating time 2 min, heating rate 1.8 °C/s) allowed to obtain a product that meets both the strength and geometric requirements. The determined optimal process’ parameters were later transferred to the stamping process of elements of a more complex shape (lower part of the B-pillar). The sheet was heated up and formed in the previously pre-heated tools. In the subsequent series of tests, the heating method and the blank’s temperature were being analyzed. In the case of the foot of the B-pillar, it was necessary to lower the initial blank temperature to 200 °C (heating in a furnace with a temperature of 340 °C, heating speed 0.5 °C/s). The appropriate combination of the process parameters resulted in the satisfactory shape deviation and reaching the product’s strength comparable to the strength of the material in as-delivered T6 temper. Using electron microscopy, it was verified that the structure of the finished product contained particles MgZn 2  that strongly strengthen the alloy. The obtained results complement the data on the possibility of using 7075 aluminum alloy to produce energy-absorbing elements of motor vehicles.

Warm sheet metal forming of energy-absorbing elements made 7075 aluminum alloy in the hardened state T6