Open AccessOptimalisasi Penggunaan Frekuensi dan Peningkatan Throughput pada Jaringan LTE-A menggunakan Metode CADS2
Author(s) -
Hasanah Putri,
Minal Abi Putra
Publication year - 2021
Publication title -
elkomika
Language(s) - English
Resource type - Journals
eISSN - 2459-9638
pISSN - 2338-8323
DOI - 10.26760/elkomika.v9i1.125
Subject(s) - throughput , physics , computer science , computer network , operating system , wireless
ABSTRAKPenelitian kali ini mengamati data Operating Support System (OSS) operator untuk wilayah Ciparay Bandung. Berdasarkan data OSS, Ciparay memiliki penetrasi jaringan LTE-A sebesar 90%, hal ini menunjukkan bahwa trafik di area tersebut sangat padat. Selain itu, nilai throughput jaringan LTE-A di area ini hanya sebesar 6.8 Mbps. Hal ini masih belum memenuhi standar operator dimana throughput > 16 Mbps. Untuk mengatasi hal ini, dilakukan optimalisasi penggunaan frekuensi dan peningkatan throughput menggunakan metode Carrier Aggregation Deployment Scenario 2 (CADS2) dimana dilakukan penggabungan dua buah component carrier pada bandwidth 15 MHz di band 3 (1800 MHz) dan bandwidth 20 di band 40 (2300 MHz). Dimana pada skenario I, band 3 dijadikan primary cell dan band 40 dijadikan secondary cell. Sedangkan pada skenario II, band 40 dijadikan primay cell dan band 3 dijadikan secondary cell. Hasil yang diperoleh yaitu terjadi peningkatan rata-rata throughput sebesar 94,87 %.Kata kunci: LTE-A, OSS operator, CADS2, throughput, Ciparay Bandung ABSTRACTThis research examines operator Operating Support System (OSS) data for the Ciparay area of Bandung. Based on OSS data, Ciparay has an LTE-A network penetration of 90%, this shows that the traffic in the area is very dense. In addition, the value of LTE-A network throughput in this area is only 6.8 Mbps. This still does not meet operator standards where throughput is> 16 Mbps. To overcome this, optimization of frequency usage and increase in throughput are carried out using the Carrier Aggregation Deployment Scenario 2 (CADS2) method by combining two carrier components on a 15 MHz bandwidth in band 3 (1800 MHz) and bandwidth 20 in band 40 (2300 MHz) . In scenario I, band 3 is set as a primary cell and band 40 is set as a secondary cell, whereas in scenario II, band 40 is set as a primay cell and band 3 is set as a secondary cell. The results obtained are an increase in average throughput of 94,87 %.Keywords: LTE-A, OSS operator, CADS2, throughput, Ciparay Bandung