English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this study, springback behaviour of Dp600 (Dual Phase Steel) sheet material was investigated using air V bending technique.  As bending parameters, four different punch tip radii and four different sheet thicknesses were used. The springback values obtained from the experiments were compared with each other. At the same time, the experimental data were analysed with Response Surface Method (RSM) and Taguchi (L16) orthogonal array. The experimental data and the simulation results were found to be consistent. The signal-to-noise (S/N) ratio is used to determine the most appropriate parameter of minimum springback behaviour. Additionally, it is possible to estimate the optimal combination of the bending parameters. The signal-to-noise (S/N) ratio and the design of experiment (DOE) were utilised for the analysis of the experimental results. It was determined that the effect of these parameters on the air V bending process was based on springback behaviours.

Optimization of Spring Back in Air V Bending Processing using Taguchi and RSM Method