English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

Magnesium alloys based on Mg-Al-Zn system are very attractive materials in many industries due to their specific properties. One of common forming mariners suitable for this kind of material is the application of severe plastic deformation method. This paper is focused on the deformation behavior of AZ63 alloy at equal channel angular pressing process in the temperature range of 250-320 degrees C. For this purpose finite element analysis was used. Main attention was devoted to the influence of processing parameters on the material flow. Among other, changes of the flow during equal channel angular pressing in chosen regions of the pressed samples were monitored. As variables, temperature, friction coefficient, strain rate, phi-angle or back pressure application were chosen. The comparison of the material flow lines at different conditions shows the affecting of material flow. There are obvious considerable differences between regions adjacent to the inner radius and those adjacent to the outer radius. For example in the case mu = 0 the dead zone is delimited by the angle Psi = 36 degrees, while in the case of friction given by the coefficient mu = 0.04, the value of the angle was Psi = 26.5 degrees.

FEA of Plastic Flow in AZ63 Alloy during ECAP Process