English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The aim of this study is to improve the tribological behaviour of aluminium alloys by using grain refiner and modifier. The effects of Al5Ti1B grain refiner and Al10Sr modifier additives on friction and wear properties on A380, A357 alloys produced by pouring sand andpermanent mould casting were investigated. Abrasion tests were carried out under dry conditions against St1040 steel disc using a pin-disk system with 20 N load and 1.0 m/s sliding speed. It was determined that grain refiner and modifier additives decrease the friction coefficient and increase the wear resistance. It was determined that the samples produced by permanent mould casting method decreased the friction resistance by 9% and the abrasion resistance increased by 40% compared to the samples produced in sand mould. The lowest wear rate was obtained in A380 alloy with TiB and Sr added with a value of 4.87 × 10 –11  m 2 /N.

international journal of cast metals research

Investigation of the effect of the addition of grain refiner and modifier addition on wear properties in sand and permanent mould casting of A357 and A380 aluminium alloys