English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Objective: To examine the amount of change in color and color parameters of a composite resin (Filtek P60) polymerized by five different polymerization methods. Methods: A Teflon mold (6mm in diameter, 2mm in height) was used to prepare the composite resin discs (n=10). G1: Polymerization with inlay oven; G2: Polymerization with HQTH and autoclave; G3: Polymerization with LED and autoclave; G4: Polymerization with HQTH; G5: Polymerization with LED. Colorimetric values of the specimens before and after polymerization were measured using a spectrophotometer. The CIE L*a*b color system was used for the determination of color difference. Analysis of variance (ANOVA) was used to analyze the data for significant differences. Tukey’s HSD test and paired two-tailed tests were used to perform multiple comparisons (α=.05). Results: There were no significant differences in total color change (ΔE*ab) among the polymerization groups (P>.05). However, the lowest color change (ΔE*ab) value was 3.3 in LED and autoclave; the highest color change (ΔE*ab) value was 4.6 in HQTH. For all groups, CIE L*, C*ab and a*values decreased after polymerization (P<.05). The highest Δb* and ΔC*ab values were observed in specimens polymerized in an inlay oven (P<.05). Conclusions: Composite resin material showed color changes above the clinically accepted value in all study groups (ΔE*ab⩾3.3). All specimens became darker during investigation (ΔL*< 0). Specimens polymerized with inlay oven presented the highest Δb* values which means less yellow color in specimens.

Assessment of changes in color and color parameters of light-cured composite resin after alternative polymerization methods