English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Sheet metal formability under hot stamping conditions has been evaluated using a novel planar testing system developed previously, being used within a Gleeble machine. Nevertheless, the specimen design with the central recess was not standardised, and the thickness reduction was not applied to the dog-bone type of specimen for testing at the uniaxial straining state. In this paper, effect of thickness reduction of dog-bone specimens on limit strain measurement under hot stamping conditions is investigated, and two types of dog-bone specimens without and with central recess are presented. Thermomechanical uniaxial tensile tests were performed at various deformation temperatures and strain rates, ranging from 370–510 °C and 0.01–1/s, respectively, by using the developed biaxial testing system in the Gleeble. The distributions of temperature and axial strain along gauge region of the two types of specimen were measured and compared. The specimen with consistent thickness had a better uniformity of temperature and strain distributions, compared to that with thickenss reduction. Forming limits for both types of specimen were also determined using the section-based international standard method. It is found that the accuracy of the calculation of forming limits based on the use of specimen with thickness reduction was highly dependent on the selection of the stage of the deformation of the specimen.

Effect of the thickness reduction of specimens on the limit strains in thermomechanical tensile tests for hot-stamping studies